 ULINK® User's Guide Discontinued | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
ULINK® User's Guide
Introduction Hardware Description
USB Interface LED Indicators Jumpers Target Connectors JTAG Interface Schematics Start Sequence Reset Sequence Setting Up and Using ULINK Evaluation BoardsReset Sequence
ULINK's reset sequence is device-specific. To reset most devices, ULINK asserts the JTAG RESET signal (pin 15 on the ARM JTAG connector, pin 8 on the OCDS and ST connectors), then attempts to immediately stop the device.
Some ARM devices do not support an immediate stop after a reset and instruction execution happens before ULINK can issue a stop command. For these devices, when ULINK gets control, it stops the CPU, and then sets the MCU's program counter (PC) and stack register (CSPR) to simulate an immediate stop after reset.
Side-Effects for ARM Devices
Resetting an ARM device may generate unexpected side-effects. The following Knowledgebase Articles describe these side effects in more detail:
| Contact Site Map Press Privacy | Copyright © 2009 Keil™, An ARM® Company. All rights reserved. |
