Revely RMS100

The Revely RMS100 Evaluation Board works with the ULINK USB-JTAG Adapter. The following instructions show you how to connect and run an example program on this board.

To download and run an example project using ULINK with the Revely RMS100 Board:

1. Connect the 20-pin ribbon connector from the ULINK Adapter to the JTAG connector on the Revely RMS100 evaluation board.
2. Connect the power adapter to the board.
3. Start µVision.
4. Select the HELLO.UV2 example project from C:\KEIL\ARM\BOARDS\REVELY\RMS100\HELLO\.
5. Click the Download button to download the program to the target board.
6. Click the Debug button to start the debugger.
7. Click the Run button to start the program running on the target board.