Keil Logo

Keil MCBSTR9

The Keil MCBSTR9 Evaluation Board works with the ULINK USB-JTAG Adapter. The following instructions show you how to connect and run an example program on this board.

ULINK Adapter Connected to MCBSTR9

ULINK Adapter Connected to MCBSTR9

To download and run an example project using ULINK with the Keil MCBSTR9 Board:

  1. Connect the 20-pin ribbon connector from the ULINK Adapter to the JTAG port MCBSTR9 evaluation board.
  2. Make sure that Jumper J3 is set to GND.
  3. Connect power to the board using using a standard USB cable. Connect the other end of this cable to an unused USB port on your PC. 
  4. Select the BLINKY.UV2 example project from C:\KEIL\ARM\BOARDS\KEIL\MCBSTR9\BLINKY\.
  5. Download to Flash ButtonClick the Download button to download the program to the target board.
  6. Start/Stop Debug ButtonClick the Debug button to start the debugger.
  7. Run ButtonClick the Run button to start the program running on the target board.
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.