|
|||
| Products Download Events Support Videos | |||
Technical Support
On-Line Manuals
ULINK User's Guide
Introduction
Hardware Description
Setting Up and Using ULINK
Evaluation Boards
Analog Devices
Analog Devices ADuC702x
Analog Devices ADuC712x
Ashling
Ashling LPC2100
Atmel
Atmel EB40A
Freescale
Freescale MAC7100
Infineon
Infineon XC16x Starter Kits
Infineon Easy UTAH
Keil
Keil MCBXC167
Keil MCB2100
Keil MCB2103
Keil MCB2130
Keil MCB2140
Keil MCB2300
Keil MCBSTM32
Keil MCBSTR7
Keil MCBSTR730
Keil MCBSTR750
Keil MCBSTR9
Luminary
Luminary Stellaris Boards
Nohau
Nohau LPC3000
OKI
OKI ML674000
OKI ML67Q4003
OKI ML67Q4051
OKI ML67Q4061
OKI ML67Q5003
OKI ML69Q6203
Phytec
Phytec AT91M55800A
Phytec LPC229x
Phytec LPC3180
Phytec XC16x Boards
Revely
Revely RMS100
Samsung
Samsung S3C44001
Sharp
Sharp LH75401
STMicroelectronics
STMicroelectronics DK3300
TI
TI TMS470R1A256
TI TMS470R1B1M
TQ Systems
TQ Systems TQMX16xU
Keil MCB2300
The Keil MCB2300 Evaluation Board works with the ULINK USB-JTAG Adapter. The following instructions show you how to connect and run an example program on this board.
ULINK Adapter Connected to MCB2300
To download and run an example project using ULINK with the Keil MCB2300 Board:
- Connect the 20-pin ribbon connector from the ULINK Adapter to the JTAG port MCB2300 evaluation board.
- Make sure that Jumper J13 - JTAG is ON.
- Connect power to the board using a standard USB cable. Connect the other end of the USB cable to an unused USB connector on your PC.
- Start µVision.
- Select the BLINKY.UV2 example project from C:\KEIL\ARM\BOARDS\KEIL\MCB2300\BLINKY.
-
Click the Download
button to download the program to the target board.
-
Click the Debug button to start the
debugger.
-
Click the Run
button to start the program running on the target board.
ProductsDevelopment Tools |
Hardware & Collateral |
Downloads |
Support |
Contact |
|
 |
|||
