 ULINK® User's Guide Discontinued | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
ULINK® User's Guide
Introduction Hardware Description Setting Up and Using ULINK Evaluation Boards Analog Devices
Analog Devices ADuC702x Analog Devices ADuC712x Ashling Ashling LPC2100 Atmel Atmel EB40A Freescale Freescale MAC7100 Infineon Infineon XC16x Starter Kits Infineon Easy UTAH Keil Keil MCBXC167 Keil MCB2100 Keil MCB2103 Keil MCB2130 Keil MCB2140 Keil MCB2300 Keil MCBSTM32 Keil MCBSTR7 Keil MCBSTR730 Keil MCBSTR750 Keil MCBSTR9 Luminary Luminary Stellaris Boards Nohau Nohau LPC3000 OKI OKI ML674000 OKI ML67Q4003 OKI ML67Q4051 OKI ML67Q4061 OKI ML67Q5003 OKI ML69Q6203 Phytec Phytec AT91M55800A Phytec LPC229x Phytec LPC3180 Phytec XC16x Boards Revely Revely RMS100 Samsung Samsung S3C44001 Sharp Sharp LH75401 STMicroelectronics STMicroelectronics DK3300 TI TI TMS470R1A256 TI TMS470R1B1M TQ Systems TQ Systems TQMX16xUInfineon Easy UTAH
The Infineon Easy UTAH Evaluation Board works with the ULINK USB-JTAG Adapter. The following instructions show you how to connect and run an example program on this board.
ULINK Adapter Connected to Easy UTAH
To download and run an example project using ULINK with the Infineon Easy UTAH Board:
- Connect the 16-pin ribbon connector from the ULINK Adapter to the OCDS connector (JP2) on the Easy UTAH evaluation board.
- Install the following jumpers:
- Connect power to the board using an external 6 Volt DC power supply. The connection uses a 5.5mm barrel plug.
- Start µVision.
- Select the UTAH_BLINKY.UV2 example project from C:\KEIL\C166\BOARDS\INFINEON EASY UTAH\.
Click the Download button to download the program to the target board.
Click the Debug button to start the debugger.
Click the Run button to start the program running on the target board.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
