Configuring MON251

MON251 is easily adapted to a wide variety of target hardware. Following are the basic steps for configuring MON251 for your target. 

• Modify INSTALL.A51 to match your target hardware.
• Assemble and link the monitor using INSTALL.BAT.
• Install the MON251 program on your target hardware.
• Test the interface between the µVision Debugger and MON251.

Before you attempt to configure MON251, you MUST know how the target hardware is configured. Most configuration problems are caused by inadequate or incomplete knowledge of the underlying target hardware.

Specifically, you must know:

• The address range of the von-Neumann RAM memory for the Monitor data.
• The location where you want the target program to begin. This memory must be also von-Neumann RAM

These parameters can be derived from the schematic or memory configuration of your target hardware.