 MCBXC800 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCBXC800 User's Guide
Introduction MCBXC866 MCBXC88x Writing Programs Example Programs Using Infineon XC800 Flash Download Using Infineon XC800 Target Driver
Debugging Flash Programming Connecting to OCDS OCDS Connector Pinout XC800 Interface Connector Chaining multiple JTAG devices Configuring ULINK Target Driver Setup Target Debug Options Flash Download Options Troubleshooting Configuring DAS DAS Driver Setup Infineon DAvEOCDS Connector Pinout
The Infineon On-Chip Debug System (OCDS) connector provides a standard interface for debugging tools and programming utilities.
It is typically implemented using a 16-pin IDC connector with 0.1 inch (2.54mm) spacing. The connector pin-out is illustrated at the right.
| Pin | Description |
|---|---|
| TMS | Test mode select input (according to the IEEE 1149.1 Standard) |
| TDO | Test data output (according to the IEEE 1149.1 Standard) |
| CPUCLK | CPU clock (according IEEE Standard 1149.1) |
| TDI | Test data input (according IEEE Standard 1149.1) |
| TRST | Test reset input (according IEEE Standard 1149.1) |
| TCK | Test clock input (according IEEE Standard 1149.1) |
| BRKIN | Hardware break in (Infineon-specific) |
| TRAP | Trap condition (Infineon-specific) |
| VCC | Positive Supply Voltage |
| GND | Digital Ground |
| RESET | Chip reset (Infineon specific) |
| BRKOUT | Hardware break out (Infineon-specific) |
| OCDS | Enable/Disable OCDS interface (Infineon-specific) |
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
