 MCBXC800 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCBXC800 User's Guide
Introduction MCBXC866 MCBXC88x Writing Programs Example Programs
Example Configuration BLINKY Building BLINKY Downloading BLINKY Debugging BLINKY Checking Serial Output Using Infineon XC800 Flash Download Using Infineon XC800 Target Driver Infineon DAvEDownloading BLINKY
While you may use either the Keil ULINK USB-JTAG Adapter or the XC800 Flash Download Utility to download programs into Flash, this example uses the Keil ULINK USB-JTAG Adapter.
When the BLINKY build is complete, you may download the application to the on-chip Flash ROM using the Keil ULINK USB-JTAG Adapter.
Click the download button.
When you use the Download command for the first time, you must configure the Flash options under Project - Options for Target - Utilities as described in Downloading with ULINK.
After configuring, the Flash - Download command uses the Keil ULINK USB-JTAG Adapter for Flash programming.
The BLINKY application starts executing when you press RESET on the MCBXC800 board to verify the program downloaded.
Note
- You may enable the option Update Target before Debugging to download the BLINKY project whenever you start a Debug Session.
The downloaded program is ready for debugging.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
