 MCBXC800 User's Guide | |
| Home Products Events Support | |
On-Line Manuals
MCBXC800 User's Guide
Introduction MCBXC866 MCBXC88x Setup
MCBXC88x Board Setup MCBXC88x Board Components Connecting the MCBXC88x Configuring the MCBXC88x MCBXC88x Jumper Descriptions MCBXC88x Connectors Install USB Device Driver Configure the COM Port Theory of Operation Block Diagram PCB Illustration Schematics Technical Data Prototyping Area Microcontroller Power Supply Configuration OCDS (JTAG) Interface LEDs Push Button Potentiometer CAN Interface USB Interface Writing Programs Example Programs Using Infineon XC800 Flash Download Using Infineon XC800 Target Driver Infineon DAvEConnecting the MCBXC88x
To use the MCBXC88x Evaluation Board with ULINK, you must:
- Verify that the ULINK VCC jumper (inside the ULINK housing) is connected to Ext VCC.
- Connect ULINK to the PC via a standard USB cable.
- Connect ULINK to the JTAG connector of the MCBXC88x board.
- Make sure that J3 - BTL is OFF.
- Connect power to the MCBXC88x Board using a standard USB cable.
The following picture shows how to connect ULINK to the MCBXC88x Board.
Note
- If your application program puts the XC88x device in Power Down or Idle mode, the OCDS in the Infineon XC800 device (and subsequently the ULINK) stops working. Therefore, do not put the XC88x device device into the power saving modes during the software development cycle.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
