|
|||
| Products Download Events Support Videos | |||
Technical Support
On-Line Manuals
MCBXC800 User's Guide
Introduction
MCBXC866
MCBXC88x
Setup
MCBXC88x Board Setup
MCBXC88x Board Components
Connecting the MCBXC88x
Configuring the MCBXC88x
MCBXC88x Jumper Descriptions
MCBXC88x Connectors
Install USB Device Driver
Configure the COM Port
Theory of Operation
Block Diagram
PCB Illustration
Schematics
Technical Data
Prototyping Area
Microcontroller
Power Supply
Configuration
OCDS (JTAG) Interface
LEDs
Push Button
Potentiometer
CAN Interface
USB Interface
Writing Programs
Example Programs
Using Infineon XC800 Flash Download
Using Infineon XC800 Target Driver
Infineon DAvE
MCBXC800 User's Guide
MCBXC88x Jumper Descriptions
The jumpers used to configure the MCBXC866 board are:
-
COM: Connect UART0/COM0 Port Lines to USB, LIN, or CAN
interface:
USB: connect UART0 (shares COM0) lines to USB/COM bridge interface.
LIN: connect UART0 (shares COM0) lines to LIN interface.
CAN: connect CAN0 (shares UART0) lines to CAN driver. -
J3 - BSL: BootStrap Loader Enable for In-System
Programming:
ON: connect USB/COM bridge interface control lines to BootStrap Loader control pins (MBC, RESET).
OFF: disconnect USB/COM bridge interface control lines.
ProductsDevelopment Tools |
Hardware & Collateral |
Downloads |
Support |
Contact |
|
 |
|||
