 MCBXC800 User's Guide | |
| Home Products Events Support | |
On-Line Manuals
MCBXC800 User's Guide
Introduction MCBXC866 MCBXC88x Setup
MCBXC88x Board Setup MCBXC88x Board Components Connecting the MCBXC88x Configuring the MCBXC88x MCBXC88x Jumper Descriptions MCBXC88x Connectors Install USB Device Driver Configure the COM Port Theory of Operation Block Diagram PCB Illustration Schematics Technical Data Prototyping Area Microcontroller Power Supply Configuration OCDS (JTAG) Interface LEDs Push Button Potentiometer CAN Interface USB Interface Writing Programs Example Programs Using Infineon XC800 Flash Download Using Infineon XC800 Target Driver Infineon DAvEConfiguring the MCBXC88x
The MCBXC88x Evaluation Board is configured using the jumpers COM and J3 - BSL. The MCBXC88x Board ships with the following configuration:
| Jumper | Default | Description |
|---|---|---|
| COM | USB | Connect the UART0/CAN0 I/O pins to the USB/COM Bridge. |
| J3 - BSL | ON | Connect USB/COM Bridge control lines for Bootstrap Loader (BSL). |
In addition, the MCBXC88x Board has configuration resistors and bridges on the bottom of the board.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
