 MCBXC800 User's Guide | |
| Home Products Events Support | |
On-Line Manuals
MCBXC800 User's Guide
Introduction MCBXC866 MCBXC88x Setup
MCBXC88x Board Setup MCBXC88x Board Components Connecting the MCBXC88x Configuring the MCBXC88x MCBXC88x Jumper Descriptions MCBXC88x Connectors Install USB Device Driver Configure the COM Port Theory of Operation Block Diagram PCB Illustration Schematics Technical Data Prototyping Area Microcontroller Power Supply Configuration OCDS (JTAG) Interface LEDs Push Button Potentiometer CAN Interface USB Interface Writing Programs Example Programs Using Infineon XC800 Flash Download Using Infineon XC800 Target Driver Infineon DAvEMCBXC88x Board Setup
The MCBXC88x Evaluation Board requires a 6-12 VDC power supply.
The MCBXC88x Evaluation Board connects directly to the Keil µVision Debugger using the Keil ULINK USB-JTAG Adapter, so no additional software is required on the board. It is also possible to set breakpoints in Flash ROM which allows you to test production code.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
