|
|||
| Products Download Events Support Videos | |||
Technical Support
On-Line Manuals
MCBXC800 User's Guide
Introduction
MCBXC866
Setup
MCBXC866 Board Setup
MCBXC866 Board Components
Connecting the MCBXC866
Configuring the MCBXC866
MCBXC866 Jumper Descriptions
MCBXC866 Connectors
Theory of Operation
Block Diagram
PCB Illustration
Schematics
Technical Data
Prototyping Area
Microcontroller
Power Supply
Configuration
OCDS (JTAG) Interface
LEDs
Push Button
Potentiometer
Serial Port
CAN Interface
MCBXC88x
Writing Programs
Example Programs
Using Infineon XC800 Flash Download
Using Infineon XC800 Target Driver
Infineon DAvE
Connecting the MCBXC866
To use the MCBXC866 Evaluation Board with ULINK, you must:
- Verify that the ULINK VCC jumper (inside the ULINK housing) is connected to Ext VCC.
- Connect ULINK to the PC via a standard USB cable.
- Connect ULINK to the JTAG connector of the MCBXC866 board.
- Make sure that J6 - BTL is OFF.
- Connect power to the board using a 6V - 12V DC, 100mA power supply.
The following picture shows how to connect ULINK to the MCBXC866 board.
Note
- If your application program puts the XC866 device in Power Down or Idle mode, the OCDS in the Infineon XC800 device (and subsequently the ULINK) stops working. Therefore, do not put the XC866 device device into the power saving modes during the software development cycle.
ProductsDevelopment Tools |
Hardware & Collateral |
Downloads |
Support |
Contact |
|
 |
|||
