 MCBXC167 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCBXC167 User's Guide
Introduction Setup
Board Setup Board Components Connecting the MCBXC167 Configuring the MCBXC167 DIP Switches Jumper Descriptions Theory of Operation Writing Programs Example Programs Infineon Memtool Utility Startup CodeJumper Descriptions
The jumpers used to configure the MCBXC167 board are:
- J1 & J2 - 1M, 2M, CAN (Default: ON, ON)
These jumpers enable the CAN2 transceiver or expand the external Flash ROM address space to 2 MB.
When the jumper is set in the middle, the entire 2MByte space of the Flash ROM is accessible. The CAN2 RxD line is not connected to the transceiver. 
When two jumpers are used, the Flash ROM access is limited to 1 MB and the CAN2 RxD line is connected to the transceiver. - JP3 & JP4 - VAREF, GND (Default: ON, ON)
The VAREF and GND jumpers provide the reference voltage for the on-chip A/D converter. When these jumpers are in place, the on-board 5V reference is used. When these jumpers are removed, you must provide the A/D reference voltages to the board.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
