| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
MCBXC167 User's Guide
Introduction 
Setup 
Board Setup Board Components Connecting the MCBXC167 Configuring the MCBXC167 DIP Switches Jumper Descriptions Theory of Operation Writing Programs Example Programs Infineon Memtool Utility Startup CodeConnecting the MCBXC167
To use the MCBXC167 Board with ULINK, you must connect:
- The ULINK to the PC via a standard USB cable.
- The ULINK to the JTAG connector of the MCBXC167 board.
- Power to the board using a 6VDC, 300 mA power supply.
The following picture shows how to connect ULINK to the MCBXC167 board.
Note
- If your application program puts the XC167 device in Power Down or Idle mode, the OCDS in the Infineon XC167 device (and subsequently the ULINK) stops working. Therefore, do not put the XC167 device device into the power saving modes during the software development cycle.
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
