 MCBXC167 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCBXC167 User's Guide
Introduction Setup Theory of Operation Writing Programs Example Programs MON166 BLINKY
Building BLINKY Downloading BLINKY Debugging BLINKY Checking Serial Output OCDS BLINKY Building BLINKY Downloading BLINKY Debugging BLINKY Checking Serial Output EASYWEB Set DIP Switches for EASYWEB Building EASYWEB Downloading EASYWEB Debugging EASYWEB Checking Output PLL_DEMO Set DIP Switches for PLL_DEMO Building PLL_DEMO Downloading PLL_DEMO Debugging PLL_DEMO Checking Output TwinCAN Building TwinCAN Downloading TwinCAN Debugging TwinCAN Checking Output Infineon Memtool Utility Startup CodeDownloading PLL_DEMO
When the PLL_DEMO build is complete, you may download the HEX file to the on-chip Flash ROM of the Infineon XC167 device on the MCBXC167 Evaluation Board.
Load the executable file into either the on-chip or external Flash ROM. Your program must be Flash programmed into the ROM before you can debug it (except when on the external RAM target).
In this PLL_DEMO example, both Flash targets are already configured with the appropriate Flash Programming Algorithm. Just click the Flash Download button to download the compiled program to the MCBXC167 board.
Note
- If you enable "Update Target before Debugging" under Options for Target - Utilities, the Flash ROM on your MCBXC167 is automatically programmed when you enter the Debug Mode.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
