 MCBXC167 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCBXC167 User's Guide
Introduction Setup Theory of Operation Writing Programs Example Programs MON166 BLINKY
Building BLINKY Downloading BLINKY Debugging BLINKY Checking Serial Output OCDS BLINKY Building BLINKY Downloading BLINKY Debugging BLINKY Checking Serial Output EASYWEB Set DIP Switches for EASYWEB Building EASYWEB Downloading EASYWEB Debugging EASYWEB Checking Output PLL_DEMO Set DIP Switches for PLL_DEMO Building PLL_DEMO Downloading PLL_DEMO Debugging PLL_DEMO Checking Output TwinCAN Building TwinCAN Downloading TwinCAN Debugging TwinCAN Checking Output Infineon Memtool Utility Startup CodeDebugging PLL_DEMO
Debug the PLL_DEMO example program following this procedure. The debugged program is ready for the output check.
Configure the DIP Switches Before Starting PLL_DEMO on MCBXC167
Before you can start the PLL_DEMO application on the target hardware, you must configure the DIP Switch settings on the MCBXC167 board. Refer to Set DIP Switches for PLL_DEMO.
Start Debug
Use the Start/Stop Debug Session toolbar button or the µVision command Debug - Start/Stop Debug Session to connect the debugger to the Keil ULINK Adapter. For details on the debugging features, refer to the µVision User's Guide.
Note
- Debugging the PLL_DEMO program using the µVision debugger requires a ULINK USB-JTAG adapter.
The Peripherals Menu allows you to open different dialogs for Peripheral units on the Infineon XC167 device. You may view and/or change the state and configuration of on-chip peripherals using these dialogs. For example:
The PORT 3 dialog reflects the status of the I/O ports.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
