MCBXC167 User's GuideIntroduction Setup Theory of Operation Writing Programs Example Programs MON166 BLINKY Building BLINKY Downloading BLINKY Debugging BLINKY Checking Serial Output OCDS BLINKY Building BLINKY Downloading BLINKY Debugging BLINKY Checking Serial Output EASYWEB Set DIP Switches for EASYWEB Building EASYWEB Downloading EASYWEB Debugging EASYWEB Checking Output PLL_DEMO Set DIP Switches for PLL_DEMO Building PLL_DEMO Downloading PLL_DEMO Debugging PLL_DEMO Checking Output TwinCAN Building TwinCAN Downloading TwinCAN Debugging TwinCAN Checking Output Infineon Memtool Utility Startup Code
The EASYWEB example project, configured for ULINK debugging, displays the values of two analog inputs (AN) and AN1) on a web page.
The EASYWEB example project demonstrates assembling, compiling, linking, downloading, and debugging using the µVision IDE on the MCBXC167 board. To use this example, the Keil MCB-XC167 board needs to be connected to a network. The Keil MCB-XC167-BASIC board cannot be used for this example because it does not have an ethernet controller.
The EASYWEB project has five available targets:
Use the On-Chip Flash target for this example.
To load the EASYWEB project, select Open Project from the Project menu and open EASYWEB.UV2 from the following folder:
When the EASYWEB project opens, the µVision Project Workspace window displays the source files that make up the project.
The Abstract.txt file contains documentation about the project.
You may edit easyweb.c or review the source code. Double click on easyweb.c in the Files page of the Project Window. µVision loads and displays the contents in an editor window.
Perform the following five steps to run the EASYWEB Example on the MCBXC167 Evaluation Board:
of your data.