| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
MCBTMPM330 User's Guide
Introduction Setup Theory of Operation 
Writing Programs 
Keil MDK-ARM Application Notes Creating Application Programs Creating a Project Setting Target Options Configuring Output Files Building a Program Programming Flash Downloading to Flash Debugging Programs Debugging with ULINK Example ProgramsSetting Target Options
You must select the speed and memory configurations for your target hardware. Since these features of the MCBTMPM330 are fixed, copy the settings as shown below. The steps for setting the target options are:
- Open the Target Tab of the Project — Options for Target dialog.
Type in the XTAL (MHz) of 10.0 for the oscillator frequency. - Enter the memory ROM area for your target system in IROM1.
Enter the starting address of 0x0 in Start and the size of 0x80000 in Size.
The MCBTMPM330 has on-chip ROM from 0x0 to 0x7FFFF for a total of 0x80000 bytes.Clicking the Startup radio button assigns your startup code to this area of memory.
- Enter the RAM memory area for your target system in IRAM1.
Enter the starting address of 0x2000000 in Start and the size of 0x8000 in Size.
The MCBTMPM330 has on-chip RAM from 0x20000000 to 0x20007FFF for a total of 0x8000 bytes.
Note
- In the licensed (non-evaluation) version of MDK-ARM, the Memory Areas parameters automatically configure the scatter file for the ARM Linker/Locator.
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
