 MCBSTR9 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCBSTR9 User's Guide
Introduction Setup
Board Setup Board Components Connecting the MCBSTR9 Configuring the MCBSTR9 Jumper Descriptions Theory of Operation Writing Programs Example Programs STR91x Software Library Interrupt FunctionsConnecting the MCBSTR9
To use the MCBSTR9 Evaluation Board with ULINK, you must:
- Connect the ULINK to the PC via a standard USB cable.
- Connect ULINK to the JTAG connector of the MCBSTR9 board.
- Connect power to the board.
The following picture shows how to connect ULINK to the MCBSTR9 board.
Note
- If your application program puts the ARM device in idle or power-down mode, the Embedded ICE (and subsequently the ULINK) stops working. Therefore, do not put the ARM device into the power saving mode during the software development cycle.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
