 MCBSTR9 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCBSTR9 User's Guide
Introduction Setup
Board Setup Board Components Connecting the MCBSTR9 Configuring the MCBSTR9 Jumper Descriptions Theory of Operation Writing Programs Example Programs STR91x Software Library Interrupt FunctionsConfiguring the MCBSTR9
The MCBSTR9 Evaluation Board is configured using the jumpers J1 - J4. The MCBSTR9 Board ships with the following configuration:
| Jumper | State | Description |
|---|---|---|
| J1 - PWRDWN | ON | Connects PIN 27 of IC2 (ethernet controller) to GND |
| J2 - VBATT | ON | Connects PIN 39 of IC5 (VBatt input of STR912FW44X) to +3.3V |
| J3 - VUSB | GND | USB Device Detection at Power-Up |
| J4 - AV | ON | Connects potentiometer POT1 to P4.0 |
Configuring for the ULINK USB-JTAG Adapter
The default jumper settings (above) on the MCBSTR9 board are pre-configured for the ULINK USB-JTAG adapter.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
