 MCBSTR9 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCBSTR9 User's Guide
Introduction Setup Theory of Operation Writing Programs Example Programs BLINKY
Building BLINKY Downloading BLINKY Debugging BLINKY Checking Program Output STR91x Software Library Interrupt FunctionsDownloading BLINKY
When the BLINKY build is complete, you may download the application to the on-chip Flash ROM using the Keil ULINK USB-JTAG Adapter.
Click the download button
When you use the Download command for the first time, you must configure the Flash options under Project — Options for Target — Utilities as described in Downloading to Flash.
After configuration, the Flash — Download command uses the Keil ULINK USB-JTAG Adapter for Flash programming.
The BLINKY application starts executing when you press RESET on the MCBSTR9 board to verify the program downloaded.
Note
- You may enable the option Update Target before Debugging to download the BLINKY project whenever you start a Debug Session.
The downloaded program is ready for debugging.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
