 MCBSTR750 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCBSTR750 User's Guide
Introduction Setup
Board Setup Board Components Connecting the MCBSTR750 Configuring the MCBSTR750 Jumper Descriptions Theory of Operation Writing Programs Example Programs STR75x Software LibraryJumper Descriptions
The jumpers used to configure the MCBSTR750 board are:
- J1 - NRSTIN: Connects PIN 22 (NJTSRST) to PIN 59 (NRSTIN) of the STR750 MCU.
- J2 - P2.15: Allows soft-connect of the USB device by issuing a software restart via P2.15.
- J2 - GND: USB device is detected at powerup.
- BOOT0:Connects PIN 4 to ground.
- BOOT1:Connects PIN 27 to ground.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
