Keil Logo

Configuring the MCBSTR750

The MCBSTR750 Evaluation Board is configured using the jumpers J1, J2, BOOT0 and BOOT1. The MCBSTR750 Board ships with the following configuration:

Jumper State Description
J1 - NRSTIN OFF PIN 22 (NJTSRST) and PIN 59 (NRSTIN) are not connected and the JTAG debugger controls this pins individually
J2 - VUSB P2.15 Allows soft-connect of the USB device by issuing a software restart via P2.15
BOOT0 GND Connects PIN 4 (BOOT0) of the STR750 MCU to ground.
BOOT1 GND Connects PIN 27 (BOOT1) of the STR750 MCU to ground.

Related Knowledgebase Articles

  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.