Configuring the MCBSTR7

The jumpers used to configure the MCBSTR7 board are Boot Config Jumpers and Port Connection Jumpers as follows:

BOOT_EN	BOOT_1	BOOT_0	Memory Mapping	CPU Program Execution
DIS	any	any	Flash mapped at 0.	User code from on-chip Flash ROM.
EN¹	DIS¹	DIS¹	Flash mapped at 0.	User code from on-chip Flash ROM.
EN	DIS	EN	System Memory mapped at 0.	Factory installed boot loader from System Memory (Reserved Mode).
EN	EN	DIS	RAM mapped at 0.	User code from on-chip RAM (useful during development).
EN	EN	EN	EXTMEM mapped at 0.	System executes code from external memory.

¹ Factory setting of MCBSTR7: BOOT_EN=EN, BOOT_0=DIS, BOOT_1=DIS; user code execution from on-chip Flash ROM.

Jumper	Default	Description
X27 / ADC	ON	Connect potentiometer to P1.0
X28 / TXA	ON	Connect RS232 (A) TX to P0.9
X29 / TXB	ON	Connect RS232 (B) TX to P0.11
X30 / Term.	ON	Apply termination resistor to CAN BUS
X31 / USB_CLK	ON	Connect 48MHz USB clock to P1.10
X32 / RX	ON	Connect CAN RX to P1.11
X33 / Wake-Up	ON	Connect Wake-Up push button to P0.15
X34 / RXA	ON	Connect RS232 (A) RX to P0.8
X35 / RXB	ON	Connect RS232 (B) RX to P0.10
X36 / TX	ON	Connect CAN TX to P1.12
X37 / SHDN	ON	Connect CAN SHDN to P1.13