 MCBSTM32 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCBSTM32 User's Guide
Introduction Setup
Board Setup Board Components Connecting the MCBSTM32 Configuring the MCBSTM32 Jumper Descriptions Theory of Operation Writing Programs Example Programs STM32F10x Software LibraryJumper Descriptions
The jumpers used to configure the MCBSTM32 board are:
- VUSB: Allows soft-connect of the USB device by issuing a software restart via PD2.
- BOOT0: Can ground or drive the BOOT0 signal high.
- BOOT1: Can ground or drive the BOOT1 signal (PB2) high.
The BOOT0 and BOOT1 jumpers configure the microcontroller startup (boot) mode. This setting tells the microprocessor the location (User Flash, System Memory or Embedded SRAM) of the boot code.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
