 MCBSTM32 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCBSTM32 User's Guide
Introduction Setup Theory of Operation Writing Programs Example Programs
Using STM32_Init.c BLINKY Building BLINKY Downloading BLINKY Debugging BLINKY Checking Program Output STM32F10x Software LibraryDownloading BLINKY
When the BLINKY build is complete, you may download the application to the on-chip Flash ROM using the Keil ULINK USB-JTAG Adapter.
Click the download button
When you use the Download command for the first time, you must configure the Flash options under Project — Options for Target — Utilities as described in Downloading to Flash.
After configuration, the Flash — Download command uses the Keil ULINK USB-JTAG Adapter for Flash programming.
The BLINKY application starts executing when you press RESET on the MCBSTM32 board to verify the program downloaded.
Note
- You may enable the option Update Target before Debugging to download the BLINKY project whenever you start a Debug Session.
The downloaded program is ready for debugging.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
