| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
MCBSTM32 User's Guide
Introduction 
Setup 
Board Setup Board Components Connecting the MCBSTM32 Configuring the MCBSTM32 Jumper Descriptions Theory of Operation Writing Programs Example ProgramsConfiguring the MCBSTM32
The MCBSTM32 Evaluation Board is configured using 3 sets of 2-position jumpers. The MCBSTM32 Board ships with the following configuration:
USB Jumper
| Jumper | State | Description |
|---|---|---|
| VUSB | GND1 | Board is not detected as a USB Device. |
| VUSB | PD2 | USB Device Detection at Power-Up. |
Boot Config Jumpers
| BOOT1 | BOOT0 | Mode | Description |
|---|---|---|---|
| ---- | GND1 | User Flash | Maps User Flash to boot space. |
| GND | BOOT0 | System Memory | Maps System Memory to boot space. |
| BOOT1 | GND | n/a | |
| BOOT1 | BOOT0 | Embedded SRAM | Maps on-chip SRAM to boot space. |
1 Factory setting of MCBSTM32: User Flash Boot Mode; user code execution from on-chip Flash ROM, and USB is not detected.
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
