| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
MCBNUC1xx User's Guide
Introduction Setup 
Theory of Operation 
Block Diagram Schematics Technical Data Prototyping Microcontroller Power Supply JTAG/SW Interface LEDs Push Buttons Potentiometer USB Interface Writing Programs Example ProgramsPush Buttons
The four push buttons on the MCBNUC1xx board are:
- The Reset (S1) push button connects to the voltage monitor and the power-up reset circuit. This resets the microcontroller.
- Push buttons PE13 (S2), PE14 (S3) and PE15 (S4) connect to port pins PE13, PE14 and PE15, respectively, of the NUC140 device and are available for general use.
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
