 MCB950 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCB950 User's Guide
Introduction Setup Theory of Operation Writing Programs Example Programs Using ULINK Target Driver
Debugging Flash Programming Connecting to JTAG Configuring ULINK Target Driver Setup Target Debug Options Flash Download Options TroubleshootingTarget Driver Setup
The Target Driver Setup dialog configures the Two Wire bus interface as the debugger or for Flash programming as described below.
The dialog contains two sub-dialogs:
- Target Debug Options configures the Debugger
- Flash Download Options configures Flash Programming.
ULINK USB-JTAG Adapter
- Serial No specifies the serial number of the currently connected and selected ULINK USB-JTAG adapter. If multiple ULINK adapters are connected to your PC, then you need to select the serial number of the ULINK interface that you want to use for debugging or flash programming.
- The ULINK Version shows the type of the connected adapter. (only ULINK2 is currently possible)
- The Device Family shows which device is actually connected to the adapter.
- The Firmware Version shows the version of the ULINK adapter firmware.
- The Max JTAG Clock configures the maximum OCI clock frequency.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
