| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
MCB950 User's Guide
Introduction Setup 
Theory of Operation 
Block Diagram PCB Illustration Schematics Technical Data Prototyping Area Microcontroller Power Supply Configuration JTAG Interface LEDs Potentiometer Serial Ports USB Interface Writing Programs Example Programs Using ULINK Target DriverJTAG Interface
The JTAG Interface connector provides debugging and emulator support for the NXP P89LPC952 device. The JTAG Interface allows application debugging and programming of on-chip and off-chip Flash devices.
The standard JTAG 20-pin connector works with the Keil ULINK and many third party tool vendors.
The 2-wired Debug Interface is connected to a 10-pin (for FS2 System Navigator) connector.
Note
- The P89LPC95x only use the JTAG pins TCLK as clock and TDI as bidirectional data for communication (on the P11 connector pins 9 and 5, on the P10 connector pins 1 and 9, respectively). Remaining JTAG pins are not used and can be left open in user applications.
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
