 MCB950 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCB950 User's Guide
Introduction Setup
Board Setup Board Components Connecting the MCB950 Installing the USB Driver Configuring the COM Port Verifying the COM Connection Configuring the MCB950 Jumper Descriptions Theory of Operation Writing Programs Example Programs Using ULINK Target DriverJumper Descriptions
The jumpers used to configure the MCB950 board are:
- RUN: Fixed 3.3V on VDD: sets the operating mode for:
- running a program loaded into Flash memory
- downloading and debugging programs using ULINK2 or FS2 adapters.
- RESET: Enable Reset via UART0 USB Port: generates a CPU reset. Set this jumper to download (using Flash Magic) or debug (using ISD51) via the USB connector.
- AV: Analog Voltage for AINO: connects the POT1 potentiometer to the analog input AIN0.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
