 MCB950 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCB950 User's Guide
Introduction Setup Theory of Operation Writing Programs
Keil PK51 Professional Developer's Kit Application Notes Creating Application Programs Creating a Project Setting Target Options Configuring Output Files Building a Program Programming Flash Downloading with Flash Magic Downloading from µVision Debugging Programs Debugging with ULINK Debug Interface in Startup Code Debug Interface with Flash Magic Debugging with ISD51 Running the ISD51 Example Serial I/O with ISD51 Debugging with FS2 Setup the FS2 System Navigator Debug Interface in Startup Code Debug Interface with Flash Magic Example Programs Using ULINK Target DriverDebug Interface with Flash Magic
Enable the Debug Interface with Flash Magic using the dialog Start — Programs — Flash Magic — Flash Magic and check that the COM Port is correctly configured.
Then select the menu command ISP — Device Configuration and set the NXP P89LPC952 configuration to:
- Check Enable Reset Pin.
- Select the 2-wire JTAG debug mode from the drop-down Debug menu.
- Click on Reprogram to configure the device.
Note
- In case of errors, verify the COM connection and jumper settings (RESET: ON, RUN: OFF).
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
