 MCB950 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCB950 User's Guide
Introduction Setup Theory of Operation Writing Programs Example Programs
Example Configuration BLINKY Building BLINKY Downloading BLINKY Debugging BLINKY Checking Serial Output Using ULINK Target DriverDownloading BLINKY
When the BLINKY build is complete, you may download the HEX file to the on-chip Flash ROM of the P89LPC952 device on the MCB950 Evaluation Board.
Setup the MCB950 board as described below:
- Connect the MCB950 Board to your PC using a standard USB cable.
- Configure the Jumper Settings for FlashMagic: RUN - OFF, RESET - ON.
The two choices for Flash programming are:
- The Flash Magic Dialog Mode, or
The The downloaded program is ready for debugging.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
