 MCB950 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCB950 User's Guide
Introduction Setup Theory of Operation Writing Programs Example Programs
Example Configuration BLINKY Building BLINKY Downloading BLINKY Debugging BLINKY Checking Serial Output Using ULINK Target DriverDebugging BLINKY
After downloading the BLINKY HEX file to the on-chip Flash ROM of the P89LPC952 device, change the jumper settings on the MCB950 Board, as follows:
- Set the RUN jumper to ON
- Set the RESET jumper to OFF
- Set the AV jumper to ON to allow the potentiometer to change the LED running speed.
Use the Start/Stop Debug Session toolbar button or the µVision command Debug - Start/Stop Debug Session
To debug the MCB950 Board use:
- The ISD51 In-System Debugger that interfaces with the uVision Debugger, or
- The FS2 System Navigator that connects to the NXP LPC9xx device.
After debugging, you are ready to Check Serial Output.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
