| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
MCB950 User's Guide
Introduction 
Setup 
Board Setup Board Components Connecting the MCB950 Installing the USB Driver Configuring the COM Port Verifying the COM Connection Configuring the MCB950 Jumper Descriptions Theory of Operation Writing Programs Example Programs Using ULINK Target DriverConfiguring the MCB950
The Configuration Jumpers set the programming and run modes, and also disconnect the potentiometer, which is used as Analog Input for AD12 input.
The MCB950 Evaluation Board may be configured for the following operating modes:
- Flash Magic allows you to program the on-chip Flash ROM of the P89LCP95x using Flash Magic from Embedded Systems Academy.
- µVision/ISD51 supports In-System Debugging using the Keil ISD51 In-System Debugger.
- Run Program allows the MCB950 to execute an application stored in the on-chip Flash ROM of the P89LPC95x.
- ULINK2 allows the MCB950 to download and debug an application in the on-chip Flash ROM of the P89LPC95x.
- FS2 allows the MCB950 to download and debug an application in the on-chip Flash ROM of the P89LPC95x.
The Operating Mode Table shows the required jumper settings.
| Jumper Setting | ||
|---|---|---|
| Operating Mode | RUN | RESET |
| µVision/ISD51 | OFF | ON |
| Flash Magic | OFF | ON |
| Run Program | ON | OFF |
| ULINK2 | ON | OFF |
| FS2 | ON | OFF |
The AV Jumper connects the potentiometer to the AD12 A/D input pin.
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
