 MCB900 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCB900 User's Guide
Introduction Setup
Board Setup Board Components Connecting the MCB900 Configuring the MCB900 Jumper Descriptions Theory of Operation Writing Programs Example ProgramsJumper Descriptions
The jumpers used to configure the MCB900 board are:
- RUN: Fixed 3.3V on VDD: sets the operating mode for Flash Magic, uVision/ISD51, and User Run.
- RESET: Enable Reset via COM Port: generates a CPU reset.
- AV: Analog Voltage for A/D: connects the POT1 potentiometer to the analog input AD12.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
