 MCB900 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCB900 User's Guide
Introduction Setup Theory of Operation Writing Programs
LPC Development Studio Application Notes Creating Application Programs Creating a Project Setting Target Options Configure Output Files Building a Program Programming Flash Downloading with Flash Magic Downloading with EPM900 Emulator Debugging Programs Debugging with ISD51 Running the IDS51 Example Serial I/O with ISD51 Example ProgramsDownloading with EPM900 Emulator
Download using the EPM900 LPC Emulator. The steps to setup the MCB900 for downloading are:
- Configure for Flash Programming.
Use the toolbar button and click the Utilities tab to display the Utilities dialog, or
Select the Project - Options for Target - Utilities dialog.- Enable Use Target Driver for Flash Programming.
- Select EMP900 LPC Emulator/Programmer
- Connect and Configure
- Click on the Settings button to open the Configure EPM900 Flash Programmer dialog.
- The jumpers on the MCB900 Board must be configured for the EPM900 programmer: RUN - ON, RESET - OFF.
- The EMU/Prog jumpers on the EPM900 Board must be set to Prog, and the XTAL jumpers must be set to int.
- Click on the Settings button to open the Configure EPM900 Flash Programmer dialog.
- Download to Flash
- Disconnect power to the MCB900 board.
- Use the Flash - Download command of µVision to download the application program into the MCB900 device.
Click the Download to Flash button or use the µVision command Flash - Download to download the application program.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
