 MCB900 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCB900 User's Guide
Introduction Setup Theory of Operation Writing Programs Example Programs HELLO
Building HELLO Downloading HELLO Running HELLO BLINKY Building BLINKY Downloading BLINKY Debugging BLINKY MEASURE Building MEASURE Downloading MEASURE Debugging MEASURE Checking Serial I/ORunning HELLO
After you have built the HELLO program and downloaded it to the MCB900, change the Jumper Settings to User Run: RUN - ON, RESET - OFF, PROG - OFF and remove power from the board for a few seconds. When you restore power, the HELLO program starts running and the Port 2 LEDs blink.
View the serial output using Microsoft Windows Hyperterminal. Select Start - Programs - Accessories - Communication - Hyperterminal.
- Enter a Name for the new connection, for example: MCB900.
- Select the PC COM port COM1 under Connect Using.
- Select 9600 Bits per second, 8 Data bits, Parity None, Stop bits 1 and Flow control None.
Click OK. You should now receive Hello World messages from the MCB900 board.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
