 MCB900 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCB900 User's Guide
Introduction Setup Theory of Operation Writing Programs Example Programs HELLO
Building HELLO Downloading HELLO Running HELLO BLINKY Building BLINKY Downloading BLINKY Debugging BLINKY MEASURE Building MEASURE Downloading MEASURE Debugging MEASURE Checking Serial I/ODownloading HELLO
When the HELLO program is built, you may download the HEX file into the on-chip Flash ROM of the P89LPC932.
To setup the MCB900 board:
- Connect the COM1 connector on the MCB900 board to an unused COM port on the PC using a standard 9-pin serial cable.
- Configure the Jumper Settings for FlashMagic: RUN - OFF, RESET - ON.
- Connect the MCB900 Board to a power supply (5V-9VDC, 300mA, minimum).
For downloading, you may use either Downloading with the EPM900 Emulator or Downloading with Flash Magic.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
