| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
MCB900 User's Guide
Introduction Setup Theory of Operation Writing Programs 
Example Programs HELLO 
Building HELLO Downloading HELLO Running HELLO BLINKY Building BLINKY Downloading BLINKY Debugging BLINKY MEASURE Building MEASURE Downloading MEASURE Debugging MEASURE Checking Serial I/ODownloading BLINKY
When the BLINKY project is built, you may download the HEX file to the on-chip Flash ROM of the P89LPC935 or P89LPC932 device on the MCB900 Evaluation Board.
To setup the MCB900 board:
- Connect the COM1 connector on the MCB900 board to an unused COM port on the PC using a standard 9-pin serial cable.
- Configure the Jumper Settings for FlashMagic: RUN - OFF, RESET - ON.
- Connect the MCB900 Board to a power supply (5V-9VDC, 300mA, minimum).
You have two choices for Flash programming:
- Use the Flash Magic Dialog Mode, or
Use The downloaded program is ready for debugging.
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
