 MCB900 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCB900 User's Guide
Introduction Setup Theory of Operation Writing Programs Example Programs HELLO
Building HELLO Downloading HELLO Running HELLO BLINKY Building BLINKY Downloading BLINKY Debugging BLINKY MEASURE Building MEASURE Downloading MEASURE Debugging MEASURE Checking Serial I/ODebugging BLINKY
Debug the BLINKY example program following this procedure. The debugged program is ready for the serial output check.
When the Blinky HEX file is downloaded into the on-chip Flash ROM of the P89LPC935 or P89LPC932 device, change the jumper settings on the MCB900 Board:
- Configure the Jumper Settings for Application Run: RUN - ON, RESET - OFF.
- Set the Jumper AV to ON to allow the potentiometer to change the LED running speed.
Program debugging may be done using the µVision Debugger.
Note
- You should not have any errors when you use µVision with the provided sample projects.
Use the Start/Stop Debug Session toolbar button or the µVision command Debug - Start/Stop Debug Session
To debug the MCB900 Board use:
- The ISD51 In-System Debugger that interfaces with the uVision Debugger.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
