|
||
| Products Download Events Support Videos | ||
Technical Support
On-Line Manuals
MCB2929 User's Guide
Introduction
Setup
Theory of Operation
Block Diagram
Schematics
Technical Data
Prototyping Area
Microcontroller
Power Supply
Configuration
JTAG Interface
LCD Module
LEDs
Serial Port
CAN Interface
LIN Interface
microSD Adapter
USB Interface
Push Buttons
Potentiometers
Joystick
External RAM
Writing Programs
Example Programs
CAN Interface
The dual CAN Interfaces use the TJA1040 CAN driver (IC4 for CAN0 and IC5 for CAN1) and termination resistors (R10 and R16 for CAN0 and R17 and R18 for CAN1) on the MCB2929 board.
The CAN terminal block connector allows access to both CAN channels 0 and 1 as shown in the figure below.
Note
- CAN termination resistors make it easy to connect the MCB2929 board to your CAN network but they are not always required. When connecting the MCB2929 Board to a CAN network, you may need to remove the termination resistors.
ProductsDevelopment Tools |
Hardware & Collateral |
Downloads |
Support |
Contact |
 |
||||