|
|||
| Products Download Events Support Videos | |||
Technical Support
On-Line Manuals
MCB2929 User's Guide
Introduction
Setup
Board Setup
Board Components
Connecting with ULINK
Setting the JTAG Clock
Configuring the MCB2929
Jumper Descriptions
Theory of Operation
Writing Programs
Example Programs
MCB2929 User's Guide
Jumper Descriptions
The jumpers used to configure the MCB2929 board are:
- J1 - ADC22: Connects the ADC2/IN0 potentiometer to ADC input AD02.
- J2 - ADC0: Connects the ADC0/IN0 potentiometer to ADC input AD00.
- J3 - D-: Configures the USB Line D- for either Device or OTG mode.
- J4 - VBUS: Supplies 5 VDC to USB-B connector VBUS pin.
- J5 - D+: Configures the USB Line D+ for either Device or OTG mode.
- J6 - LED: Enables the LED driver IC.
- J7 - UMODE: Allows soft-connect of the USB device by issuing a software restart via P1.24.
- J8 - Debug: Configures the JTAG interface to Debug Mode.
- J10 - 3.3V: Supplies 3.3 VDC power for MCU IO.
- J11 - 1.8V: Supplies 1.8 VDC power for the MCU core.
ProductsDevelopment Tools |
Hardware & Collateral |
Downloads |
Support |
Contact |
|
 |
|||
