Keil Logo

Connecting with ULINK

To use the MCB2929 Evaluation Board with ULINK or ULINK2, you must:

  • Connect ULINK or ULINK2 to the PC via a standard USB AB cable.
  • Connect the 20-pin ribbon cable from ULINK or ULINK2 to the JTAG connector of the MCB2929 board.
  • Connect power to the board using a standard USB AB cable.
  • Set the JTAG clock for your ULINK or ULINK2 adapter.

The following picture shows how to connect ULINK to the MCB2929 board.

MCB2929 Board Connected to the ULINK2 JTAG Adapter

Note

  • If your application program puts the ARM device in idle or power-down mode, the Embedded ICE in the LPC2000 core (and subsequently the ULINK) stops working. Therefore, do not put the ARM device into the power saving modes during the software development cycle.
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.