Keil Logo

Configuring the MCB2929

The MCB2929 Evaluation Board is configured using a number of jumper settings. The MCB2929 Board ships with the following configuration:

Jumper State Description
J1 - ADC2
ON Potentiometer ADC2/IN0 is connected to ADC input AD02.
J2 - ADC0
ON Potentiometer ADC0/IN0 is connected to ADC input AD00.
J3 - D-
Dev Configures the USB Line D- for Device mode.
J4 - VBUS
ON
Supplies 5 VDC to USB-B connector VBUS pin.
J5 - D+ Dev
Configures the USB Line D+ for Device mode.
J6 - LED
ON Enables the LED driver IC that powers the 8 I/O port LEDs.
J7 - UMODE P1.24 Allows soft-connect of the USB device by issuing a software restart via P1.24
J8 - Debug ON Configures the JTAG interface to Debug Mode
J10 - 3.3V
ON Supplies 3.3 VDC power for MCU IO.
J11 - 1.8V
ON
Supplies 1.8 VDC power to the MCU Core.

Configuring for the ULINK USB-JTAG Adapter

The default jumper settings (above) on the MCB2929 board are pre-configured for the ULINK USB-JTAG adapter.

  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.