| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
MCB2900 User's Guide
Introduction Setup Theory of Operation 
Writing Programs 
ARM Microcontroller Development Kit Application Notes Creating Application Programs Creating a Project Setting Target Options Configuring Output Files Building a Program Programming Flash ULINK USB-JTAG Adapter Debugging Programs Debugging with ULINK Example ProgramsSetting Target Options
You must select the speed and memory configurations for your target hardware. Since these features of the MCB2900 are fixed, copy the settings as shown below. The steps for setting the target options are:
- Open the Target Tab of the Project — Options for Target dialog.
Type in the XTAL (MHz) of 10.0 for the oscillator frequency. - Enter the memory ROM area for your target system in IROM1.
Enter the starting address of 0x20000000 in Start and the size of 0xC0000 in Size.
The MCB2900 has on-chip ROM from 0x20000000 to 0x200BFFFF for a total of 0xC0000 bytes. - Enter the RAM memory area for your target system in IRAM1.
Enter the starting address of 0x80000000 in Start and the size of 0xC000 in Size.
The MCB2900 has on-chip RAM from 0x80000000 to 0x8000BFFF for a total of 0xC000 bytes.
Note
- In the licensed (non-evaluation) version of MDK-ARM, the Memory Areas parameters automatically configure the scatter file for the RealView Linker/Locator.
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
