| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
MCB2900 User's Guide
Introduction 
Setup 
Board Setup Board Components Connecting with ULINK Setting the JTAG Clock Configuring the MCB2900 Jumper Descriptions Theory of Operation Writing Programs Example ProgramsJumper Descriptions
The jumpers used to configure the MCB2900 board are:
- J1 - DEBUG: Select JTAG debugging or JTAG boundary scan: ON selects ARM debug mode. OFF selects boundary scan mode.
- J2 - AV: Enable Analog Voltage Input: Connects the P0.2 to the analog voltage output from the potentiometer POT1.
- J6 - LED: Enable Port LED Driver:Enables the 74HCT244 Line Driver which controls the 8 port LEDs.
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
