| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
MCB2900 User's Guide
Introduction 
Setup 
Board Setup Board Components Connecting with ULINK Setting the JTAG Clock Configuring the MCB2900 Jumper Descriptions Theory of Operation Writing Programs Example ProgramsConfiguring the MCB2900
The MCB2900 Evaluation Board is configured using the jumpers J1, J2 and J6. The MCB2900 Board ships with the following configuration:
| Jumper | State | Description |
|---|---|---|
| J1 - DEBUG | ON | Configures the JTAG interface to Debug Mode. |
| J2 - AV | ON | Connects P0.2 to the analog voltage controlled by the potentiometer POT1. |
| J6 - LED | ON | Enables the driver chip that controls the 8 I/O port LEDs. |
Configuring for the ULINK USB-JTAG Adapter
The default jumper settings (above) on the MCB2900 board are pre-configured for the ULINK USB-JTAG adapter.
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
