| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
MCB2900 User's Guide
Introduction Setup Theory of Operation Writing Programs 
Example Programs BLINKY 
Building BLINKY Downloading BLINKY Debugging BLINKY Checking Program OutputDebugging BLINKY
Debug the BLINKY example program following this procedure. The debugged program is ready for the serial output check.
Use the Start/Stop Debug Session toolbar button or the µVision command Debug — Start/Stop Debug Session to connect the debugger to the Keil ULINK Adapter. The CPU stops and connects to the Embedded ICE of the LPC29xx device. For details on the debugging features, refer to the µVision User's Guide.
Note
- Debugging the BLINKY program using the µVision Debugger requires a ULINK USB-JTAG adapter.
The Peripherals menu allows you to open different dialogs for Peripheral units on the LPC29xx devices. You may view and/or change the state and configuration of on-chip peripherals using these dialogs. For example:
The GPIO dialog reflects the status of the I/O ports.
The Phase Locked Loop (PLL) dialog shows the core clock configuration of the LPC2900 device.
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
